Usage: Steel, Brass, Nickel Silver & Copper
Our biggest seller and for most modeler#s the flux they instinctively turn to. It is suitable for use with steel, but not stainless steel, Copper, Brass, nickel silver and similar alloys. It is an active flux and leaves residues that are corrosive. For that reason, care should be taken to remove these. An initial wash in Neutralising Rinse followed by several washes with water should remove all traces.
As supplied, a high quality synthetic (oil based) brushing enamel paint.
Stir thoroughly with a spatula (lollipop stick, wooden coffee stirer etc.) for a minimum of 5-10 minutes, or a power stirer. Ensure that you get into the bottom corners of the can and bring any sediment to the surface and stir in.
May be thined if required.
Matt colours may require more thinning.
This product is best brushed or sprayed at a temperature of below 10° Centigrade ( 50°F). and left for a Minimum of 24 - 48 hours to dry before any overcoating or further actions are taken.
Apply over the top of a properly primed surface.